Billtex2000
Jetboaters Admiral
- Messages
- 1,191
- Reaction score
- 2,677
- Points
- 312
- Location
- Lake Wallenpaupack, PA
- Boat Make
- Yamaha
- Year
- 2006
- Boat Model
- SX
- Boat Length
- 21
-
Welcome to Jetboaters.net!
We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!
Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
-
Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.
Click Here for more information>Ride Steady group buy for JetBoaters.net members only
You can dismiss this Notice by clicking the "X" in the upper right>>>>>
Wakesurf Edge Wave Enhancer
- Thread starter Billtex2000
- Start date
Blenderhead
Jet Boat Junkie
- Messages
- 196
- Reaction score
- 214
- Points
- 137
- Location
- Spout Springs North Carolina
- Boat Make
- Malibu
- Year
- 2018
- Boat Model
- Other
- Boat Length
- 21
I am sure they work great, however on my 2017 212x there aren't any flat surfaces on the rear/side of the boat that sit deep enough in the water for it to effectively enhance a wake. You can argue that if you added enough ballast you could bring either of the stern corners down deep enough to work, however you still have to deal with the "jet wash" which is the biggest hindrance of a clean surfable wake. Additionally the vinyl graphics that exist on that area of my boat do not allow good enough suction. Only proven wake shaper for the Yamaha jetboats as of right now is the Gantlin Wake wedge.
JasonSchoenrock
Jet Boat Junkie
- Messages
- 66
- Reaction score
- 115
- Points
- 132
- Location
- North Carolina - Lake Norman
- Boat Make
- Yamaha
- Year
- 2016
- Boat Model
- Limited S
- Boat Length
- 24
I have one I'll sell you. I tried it out and as stated above, it just doesn't sit low enough to make a noticeable difference. I also had to put in on over the graphic decals and it tore off and ripped up the stickers..
Similar threads
