Rotax Engine Forum now available!

[RodK]

Hi.. I have a 2016 223 VR with 2 x150's. Today i was unable to start either engine. I then looked at the app and found an error code PO420 (port). I reset all settings to factory settings and then got both engines to start. On returning the error message re-appeared while i was running.
Does anyone know what this error message is?

 

[BobJohnson]

Hi.. I have a 2016 223 VR with 2 x150's. Today i was unable to start either engine. I then looked at the app and found an error code PO420 (port). I reset all settings to factory settings and then got both engines to start. On returning the error message re-appeared while i was running.
Does anyone know what this error message is?

This is what the code stands for.... Catalyst conversion insufficient

what needs to be done I don't know.... attached is a list of all codes....

 

[RodK]

Hi Bob
Thanks very much for that .. very helpful !

 

[RodK]

On winterizing my boat i found a cable next to starboard engine which wasnt connected to anything. I looked around and under the engine (as far as one can) and couldnt see any obvious place for it. Moving the throttle and gear levers didnt activate the cable at all. I had no malfunction of the boat prior to taking it out of the water !.. Anyone have an idea what it is and where it goes?